This Audemars Piguet case is different from other low-cost replica Audemars Piguetsr

All firmware for the entire AP, of course for aesthetic reasons. As well as the explanations that follow, I didn't have all the screws that were placed separately. Audemars Piguet's watch consists of 3 sets of 24 screws, which are undoubtedly built of screws.

If you have a good understanding of the authentic Audemars Piguet Royal Oak, you can know that the authentic Audemars Piguet's unique screw style was conceived in one night. Thus, it has continued to this day, and a hexagonal screw has become a unique symbol of Audemars Piguet. In the low-end era of high imitation, there is no real hexagonal screw. Here you have to admire the early opening. The model of the "earth and fine" early high imitation table, the hexagonal screw is directly with a stainless steel piece engraved with traces of similar screws, and swiss replicas watches achieved the effect. Of course, even now, there are molders, in order to save costs, this is still the case. In the high-end Aibeigao imitation table, all the upper screws are real screws, but the screws must be tightened, and the screws will inevitably appear to be twisted, but hundreds of thousands of genuine. Like the high imitation watch of thousands of dollars, it is equally afraid of scratches, and the scratches on the front screws are absolutely not allowed.

This Audemars Piguet case is different from other low-cost Audemars Piguets. Since the screw locking method is the same as the genuine one, the screw bottom cover and the push-type bottom cover are naturally unusable. But there is no doubt that the locking method of the screw-type bottom cover is the best choice for waterproofing. We can see that this Audemars Piguet part has a thick rubber ring, which is waterproof as the front cover. The sealing ring, in the screw locking part of the back cover, also has a specially designed rubber layer for waterproof design. There is also a waterproof ring in the inner groove of the movement, so that this can be locked by the screw. The watch, no matter from the front. The back cover, as well as the button part, can achieve perfect waterproof effect, but nevertheless, I personally do not recommend this watch as a standing diving watch because of its waterproof firmware, front rubber firmware, rear rubber firmware The rubber firmware of the head, the rubber firmware in the movement slot, the rubber firmware of the eight small screws on the front cover fake watches, and the rubber ring are composed of 12 rubber rings. Under the premise of long-term wear, you cannot determine which firmware is aging and affect the waterproof. Effect. Therefore, whether it is genuine or high imitation, I personally do not recommend the Audemars Piguet watch as a diving standing watch.